Old World aesthetics and a modern full-bodied tonal range
Played clean, it sounds incredibly acoustic and detailed. But when the volume kicks up it screams louder and longer than any guitar you've played without unwanted feedback or breakup.

The Model 1's have our in-house-made "hot humbucker", the passive models run just straight out with a volume and tone control with a push-pull coil cut switch on the tone control. When we add the D-TAR Eclipse preamp ( "B" option ), we are using the same pickup but with a high-headroom 18 volt preamp that has trim potentiometer adjustable gain which allows anywhere from 3 to 12 dB of additional gain and a buffered output that takes guitar cable capacitance out of the picture. The Eclipse preamp has the same basic controls...master volume and push/pull tone with coil cut, and also has a second input channel allowing the addition and blending of a piezo pickup or a second magnetic pickup.

Model 1 Controls

When you have complete electronics, ( "C" option ), first switch the EQ out. Then adjust the tone control all the way up and then blend back and forth between the magnetic and piezo pickups. This is very different from the usual Les Paul or Strat pickup selection, and acts more like a zoom lens on a camera ranging from the more mid focused sound of the magnetic pickup to the more acoustic and wide range piezo pickup, which actually has more deep lows as well as more extended highs. When you are in the "just magnetic pickup" position on the blend knob, try pulling up on the tone knob to access the single coil sound. That is a sound more akin to the middle pickup on a Strat.

When you've learned your way around without the EQ, find a tone you like and then kick in the EQ with the Boost/Cut knob turned about 1/2 of the way up from the middle detent position. This would put the knob line at the 9:00 position relative to the detent being 6:00. Then sweep the middle frequency knob to hear how the boost affects tone at different registers. For the full out sound, crank the EQ boost all the way up and repeat the frequency sweep. If you are playing into a tube amp or distortion unit, you can use the EQ to voice overdrive harmonics. Lesser boost is great for finding nice tones into a clean amp as well. While most folks don't use the "Cut" feature of the EQ, that, too, has some very nice uses.